AudioBahn Audiobah XM Ready A1100N - Manual (Page 12)

SWITHCHING ON/OFF THE UNIT
Switch on the unit by pressing any
button(except OPEN button(7)and £
button (4)). When system is on, press
0 PWR button(9)toturnofftheunit.
FACEPLATE RELEASE
Press OPEN button (7) to detach the
removable faceplate.
SOUNDADJUSTMENT
Press SEL button (10) to select the
desired adjustment mode.
The adjustment mode will change in
the following order:
VO^ _^BA^^TRE _^BAL _^AD
(Volume)^!^ (Bass) ^j^(Treble) (Balance) (Fader)~|
By rotating the VOL knob (11) clockwise
or counter-clockwise, it is possible to
adjust the desired sound quality.
Pressandholdthe SEL button(10)for
several seconds to enter into the
selection for the situation of beep sound,
then rotate the VOL knob (11) clockwise
or counter-clockwise to select as
follows:
BEEP2ND ---------------H>-BEEPALL --------------- •'► BEEPOPP
- BEEP 2ND mode:
The beep is only generated when all
allowed double function button is
pressed long (several seconds),
e.g.
When preset button is pressed.
When BND/LOU button(13)is
pressed.
When AS/PS button (18) is pressed.
- BEEPALLmode:
The beep is generated when every
button is pressed.
- BEEPOFFmode:
The beep is disabled.
LOUDNESS
Press BND/LOU button(13)for
several seconds to reinforce the bass
output. Press it for several seconds
again to release this function.
DISPLAYINFORMATION
When pressed quickly, the DSP button
(15) changes the display as follows.
- InAM/FMmode:
-> Frequency ->CLOCK ->
- In XM mode:
-> Channel Name -> Category Name
-> Artist Name -> Song Title ->
CLOCK->
- In CD mode:
-> CD->CLOCK->
- lnCDC(orAUX)mode:
-> CDC(orAUX)->CLOCK->
Each displaying time is 5 seconds,
the display will return to the first
position after 5 seconds.
SETTHECLOCK
Pressthe DSP button(15)shortlyuntil
the clock is shown on the display. Then
holddown DSP buttonuntiltheclock
flashes.Then press the TUNE/TRACK
►►I button (17) to change hours or
TUNE/TRAC^ «◄button (16) to change
minutes.
MUTE
Press MUT button(3)tomutedown
the sound instantly. Ifany button is
pressed in the mute state, the mute
state is released.
EQUALIZATION
Press P-EQ button(19)toturnon
equalization function and to select
desiredaudiomode. Therearefive
kinds of mode as below:
♦FLAT-l»- CLASSICS-)»- POPM-)»- R0CKM-)»- DSPOFF^
SUBWOOFER
Press MOD button(6)forseveral
seconds to toggle subwoofer output.
Press it for several seconds again to
release this mode.
LIQUIDCRYSTALDISPLAY
Exhibit current frequency and
activated functions on the display (8).
REMOTE SENSOR
Point the remote cantrol handset to
the remote sensor (26). Press the
function keys on the handset to
control the system.
FLASHING LED
Ifthe front panel does not install in the
main unit, the LED (12) will be flashing.
RESETFUNCTION
RESET button(27)mustbeactivated
10