Troubleshooting – AudioBahn Audiobah XM Ready A1100N User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
Before going through the checklist, check wiring connection. If any of the problems
persist after checklist has been made, consult your nearest sen/ice dealer.
Symptom
Cause
Solution
No power.
The car ignition switch is
noton.
If the power supply is
connected to the car accessory
circuits, but the engine is not
moving, switch the ignition key
to "ACC ".
The fuse is blown.
Replace the fuse.
Disc cannot be
loaded or ejected.
Presence of CD disc inside
the player.
Remove the disc in the player,
then put a new one.
Inserting the disc in reverse
direction.
Insert the compact disc with
the label facing upward.
Compact disc is extremely
dirty or defective disc.
Clean the disc or try to play a
new one.
Temperature inside the car
is too high.
Cool off or until the ambient
temperature return to normal.
Condensation
Leave the player off for an hour
or so, then try again.
No sound.
Volume is in minimum.
Adjust volume to a desired level.
Wiring is not properly
connected.
Check wiring connection.
Sound skips.
The installation angle is
more than 30 degrees.
Adj ustthe installation angle less
than 30 degrees.
The disc is extremely dirty
or defective disc.
Clean the compact disc, then
try to play a new one.
The operation keys
do not work.
The built-in microcomputer
is not operating properly
due to noise.
Press the RESET button.
Front panel is not properly fixed
into its place.
The radio does not
work. The radio
station automatic
selection does not
work.
The antenna cable is not
onnected.
Insert the antenna cable firmly.
The signals are too weak.
Select a station manually.
19