Aiwa Z-L70 - Manual (Page 18)

RECORDING
This section explains how to record from the tuner, CD player,
or external equipment.
2
1
To stop recording, press ■.
To pause recording, press II. (Applicable when the recording
source is TUNER, PHONO or VIDEO/AUX.)
To resume recording, press again.
To start recording with the remote control
First press •/OREC/REC MUTE, and then press within 2
seconds.
NOTE
“Can’t REC” is displayed if you attempt to record on a tape with
the plastic tabs broken off.
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone (except BBE) of the speakers or
headphones are freely varied without affecting the recording.
Preparation
• Set the tape to the point where recording will start.
• Use Type I (normal) and Type II (high/Cr02) tapes for recording.
1 Insert the tape to be recorded on into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
r ........
-H-----------
----}---------- 0----)—
' ^ L
2 Press REV MODE to select the reverse mode.
To record on one side only, select Z.
To record on both sides, select Z.'i or Cl).
3 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from the connected source, press PHONO or
VIDEO/AUX and play.
4 Press #REC/REC MUTE to start recording.
I~. p'l ^^ V\y;) —
When the selected function is CD, playback and recording
start simultaneously.
To erase a recording
Make sure the microphone is not connected to the unit.
Set the microphone volume to MIN (page 22)
Insert the tape to be erased into Deck 2 and press TAPE/
DECK 1/2 to display “TP2”.
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing REV MODE.
Press #REC/REC MUTE to start the erasure.
18
ENGLISH