Aiwa LCX-350 - Manual (Page 15)

PROGRAMMED EDIT
RECORDING
4,5
4
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
Use the remote control from steps 3 to 8.
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Selected track Program
number number
U
u
n i l I
r U D
Remaining time of side A Programmed tracks
1 .1.
H I I I I - I I I
-- r
7 Press the EDIT/CHECK button while pressing the
SHiFT button to select side B and program the
tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
r/
j j
I I I I 1 1 I
- J
U U u
o
;z
b
ir
O
o
111
ir
1 insert the tape into the deck.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press the CD button on the main unit so that "CD"
is dispiayed, and ioad the disc.
You can press the FUNCTION button on the remote control
repeatedly to display "CD."
3 Press the EDiT/CHECK button twice whiie
pressing the SHIFT button.
I I n I h / l ! I I I I
r u I I i_ ' U U
8 Press the • button and then press the ^ button
within 2 seconds to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button while pressing
the SHIFT button to select side Aor B, and press the ►► button
repeatedly.
Track number Program number
4 Press the numbered buttons to designate the
tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
• The ◄◄ and ►► buttons are also available to designate
the tape length.
5 Press the numbered buttons to program a track.
Example: To select the 10th track, press the numbered buttons
+10 and 0.
8 n n ~ l
r LI D
Programmed tracks
To change the program of each side
Press the EDIT/CHECK button while pressing the SHIFT button
to select side A or B, and press the ■ button to clear the program
of the selected side. Then program tracks again.
To ciear the edit program
Press the ■ button twice.
NOTE
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
ENGLISH
1 4