Aiwa LCX-350 - Manual (Page 16)

SETTING THE TIMER
1,2,3,4
The unit can be turned on at a specified time with the built-in
timer.
Preparation
Make sure the clock is set correctly. (See page 5.)
4 Select the duration for the timer-activated period
with the ◄◄ or ►► button and press the II
button.
/ I I
O U
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD, load the disc.
To listen to a tape, insert the tape into the deck.
To listen to the radio, select the desired band and tune in to
a station.
To listen to the equipment connected to the AUX Jacks,
set the timer of the connected source (with an external timer)
and prepare for the play.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
© remains on the display after the power is turned off (timer
standby mode).
Use the remote control.
1 Press the TIMER button repeatedly while pressing
the SHIFT button to display ©, and press the II
button within 6 seconds.
0 is diaplayed, and the hour flashes.
/ fAW I I I I I I
n i l l l _ U U
I I h A
r I I
I I l - . J L
I U - l - l
When the timer-on time is reached, the unit turns on
begins play with the selected source.
and
To check the specified time and source
Press the TIMER button while pressing the SHIFT button on the
remote control. The timer-on time, the selected source name
and the duration for the timer-activated period are displayed for
4 seconds.
NOTE
If you do not press the II button within 6 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the ◄◄ or ►► button, and the II button.
Repeat to designate the minute of the timer-on
time.
I I h A I I I I
m I /_/ ■_//_(
After you designate the timer-on time, one of the source name
flashes alternately on the display.
3 Press the FUNCTION button repeatedly to select
a source and press the II button.
You can select a source by pressing the ◄◄ or ►► button
as well.
• If the tuner is selected, the band cannot be selected in this
step.
TIMER RECORDING
Timer recording is applicable for TUNER and AUX (with an
external timer) sources only.
Press the TIMER button repeatedly while pressing the
SHIFT button on the remote control so that © and
liT3R appear on the display, and press the II button.
Repeat the steps shown above from step 2 and insert the tape
to be recorded into the deck after step 5.
To cancel timer stanby mode temporarily
Press the TIMER button while pressing the SHIFT button on the
remote control so that 0 (and disappear on the display.
To restore the timer standby mode, press again to display ©
(and BIS).
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
15 ENGLISH