6 mounting – Aiphone YAZ-90-3W User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 MOUNTING
DIP SWITCH (Back of the front case)
YAZ-90-3W unit is designed for wall-mounting and the terminal section is located on inside of
the chassis. Be sure to run cable through conduit or in the wall and mount the YAZ-90-3W
unit onto single-gang box.
Wall-mounting
1. Loosen a screw and separate the front case from chassis.
2. Unplug connector from the receptacle on back of front case.
3. Attach chassis onto single-gang box.
4. Connect wires to the terminals on the chassis attached.
5. Attach connector to the receptacle again.
6. Hook front case to chassis at its top.
7. Attach front case to chassis by the screw.
- 6 -