Aiphone YAZ-90-3W - Manual (Page 8)

PAGING TO A SINGLE ZONE (when YAW-RB is used)
^ ADAPTOR No. (0 ■9)
iij*./-PAGE button
-i
Lift handset. Press [Xj button.
Press a number button 0 to 9 assigned for YAW-RB.
Transmit your message while holding down PAGE button.
Replace handset.
8
TECHNICAL PRECAUTIONS
Operating temperature
The YAZ-90-3W is rated to operate between temperatures 0°C~ +40°C (32°F ~ 104T).
Cleaning
Clean the YAZ-90-3W equipment with a soft cloth dampened with neutral household cleanser. Never use any abrasive
cleaner or cloth.
At the end of communication, be sure to replace handset on cradle properly. If not, the YAZ-90-3W will not receive a call.
9
SPECIFICATIONS
• Power source
• Current consumption
• Communication
• Talk channel
• Station selection
• Wiring
Wiring distance
Permitted line resistance
: DC 24V. Use a PS-2420 power supply(ies).
: Maximum 80mA (per station). Standby: 25mA.
: Simultaneous with handset.
: Maximum 3 channels.
: 2-digit dial (No.10 ~ 99).
2- twisted pairs in parallel for 1 channel (1- 2, + -“").
3- twisted pairs in parallel for 2 channels (1-2, 3-4, + -““).
4-
twisted pairs in parallel for 3 channels (1-2, 3-4, 5-6, + -
: 2.9Km with 0.8mm dia. (1.8 mile with 20AWG) in total.
: Less than 200 Ohm Loop for communication line.
Less than 20 Ohm Loop for power line.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. «Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help.
•F WARRANTY
^ Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period **•
of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective ^
upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make 4-
the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the
warranty.
^
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation
of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. ^
This warranty does not cover batteries or damage caused by batteries used in connection with the unit. X
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone. -t*
Aiphone will not be responsible for any costs incurred involving on site service calls.
AIPHONE CO., LTD., NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE S.A., WISSOUS, CEDEX, FRANCE
O a i p h o n e
P r o v i d i n g P e a c e o f M i n d
http://www.aiphone.com/
8 - Printed in Japan (E)