Attaching the loader to your tractor – Allied Telesis S795 TSL User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the Loader to Your Tractor
1. Position the tractor as centrally as possible and drive, using lowest gear possible, into the
loader frame until hoses can be connected.
2. Couple up the hydraulic hose lines to the loader or tractor valve ensuring proper function
(see Operator and Maintenance Section).
NOTE: When mounting the loader for the first time,
slowly work the cylinders back and forth, so that most
of the air is removed. Loosen the bolts on the hooks so
that they can be moved. Also, check that the nuts in the
rear of the subframes are in line with the holes.
3. On some tractors, the lift (flinders may have to be
extended slightly, so that the subframes can clear the front
axle. Do not extend the cylinders more than is required.
IMPORTANT!
On
HSL
l¿aders,
the
bucket will dump at the same time the
loader is lowered. Therefore, operate
both hydraulic levers together.
4. Drive the tractor ahead until the subframe is past the front axle
and the front hook is close to mounting boss.
A
WARNING!
Check
front
grill
clearance
during installation to avoid tractor damage.
5. Retract or extend the lift cylinders to line up the front hook with the mounting boss.
A
IMPORTANT! On HSL loaders, the
bucket will roll back at the same
time the loader is lowered.
Therefore, operate both hydraulic
levers together.