Attaching the loader to your tractor, Continued) – Allied Telesis S795 TSL User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the Loader to Your Tractor
(Continued)
6. When the hook is lined up, dump or roll back the bucket to lower or
raise the subframe upright to align with the mounting boot.
7. Continue to drive the tractor forward until the subframe uprights are
seated in the boot.
8. Secure the subframe uprights with the bolts and
washers. Torque to 500 ft-lbs.
IMPORTANT: When mounting for the first
time, the front hook bolts will have to
be
tightened
after
positioning
the
hook directly over the mounting boss
(most rearward position).
9. Raise the loader and lock the support stand tubes into the
NOTE: When mounting for the first time,
raise the loader slowly and check to
make sure that the hoses do not bind
or become pinched in all positions.
Work the loader and bucket up and
down to work out ail the air in the
hydraulics.
Check
and
refill
the
tractor's hydraulic system.