Manual tuning, Press the upa or downt button to select a station, Direct tuning – Aiwa AV-D50 User Manual

Page 13: 1 press the tuner button to select a band, 2 press the tuner button and hold it down until, Flashes on the display (directtuning mode), To cancel the direct tuning mode, To search for a station quickly (auto search), When an fm stereo broadcast contains noise, Manual tuning direct tuning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

RADIO RECEPTION

MANUAL TUNING

MONO

TUNER

1 Press the TUNER button repeatedly to select the

desired band.

FM------- ► AM •

cr

n

The display changes to frequency indications after indicating
band and video source (V1, V2 or V3) for two seconds.
When the TUNER button is pressed while the power is off,
the power is turned on directly.

Press the UPA or DOWNT button to select a
station.

Each time the button is pressed, the frequency changes.

When a station is received, “TUNE” is displayed for two
seconds. During FM stereo reception, is displayed.

DIRECT TUNING

c5g

LIJ

UJ

o2
ci5°

«I **

cn“:

When you know the frequency of the desired station, you can
tune in directly to the station.

1 Press the TUNER button to select a band.

2 Press the TUNER button and hold it down until

“.... ’’flashes on the display (DirectTuning Mode).

3 Press the appropriate numbered buttons to tune

in to the desired station.

Example:

To tune in to 106.50 MHz, press 1,0, 6, 5 and 0 buttons.
To tune in to 95.20 MHz, press 9, 5, 2 and 0 buttons.

To cancel the Direct tuning mode

Press the UPA or DOWNT button.

To search for a station quickly (Auto Search)

Keep the UPA or DOWNT button pressed until the tuner starts
searching for a station. After tuning in to a station, the search

stops.
To stop the Auto Search manually, press the UPA or DOWNT
button.
• The Auto Search may not stop at stations with very weak

signals.

When an FM stereo broadcast contains noise

Press the MONO TUNER button on the remote control so that
“MONO” appears on the display.
Noise is reduced, although reception is monaural.

MONO

I

' When entering a frequency out of tuning range, the value

flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.

■ When entering a frequency not covered by the tuning interval,

the value is automatically rounded up or down to the closest
one covered by it.

' The DIGIT buttons on the remote control can not be used when

tuning in to the desired station.

To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.

Hold down the TUNER button and press the POV^/ER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about half
a second.

To reset the interval, repeat this procedure.

To restore stereo reception, press the button so that “MONO”
disappears.

ENGLISH 12

Advertising