Sening the sleep timer, Care and maintenance, To clean the cabinet – Aiwa AV-D50 User Manual
Page 18: 1 press the aiwa receiver button, 2 press the sleep button, To specify the time until the power is turned off, To cancel the sleep timer, Setting the sleep timer, Sening the sleep timer care and maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEniNG THE SLEEP TIMER
CARE AND MAINTENANCE
Occasional care and maintenance of the unit is needed to
optimize the performance of your unit.
To clean the cabinet
Use a soft dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
The receiver can be automatically turned off at a specified time.
1 Press the AIWA RECEIVER button.
2 Press the SLEEP button.
The unit will be turned off after about 60 minutes.
To specify the time until the power is turned off
Press the UPA or DOWNT button on the main unit repeatedly
within four seconds after step 2.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining untii the power is turned off
Press the SLEEP button once. The remaining time is displayed
for four seconds.
To cancel the sleep timer
Press the SLEEP button twice so that “SLEEP” on the display
disappears.
The UP^M or DOWNM^ button on the remote control cannot
be used to specify the time until the power is turned off. Use the
buttons on the main unit.
1 7
ENGLISH