Admiral AW-05CR1FHLU - Manual (Page 4)

AIR CONDITIONER SAFETY
The portable air conditioner should be connected
to a 115 V, 60 Hz. 15- or 20-amp fused 3-prong
grounded outlet.
The use of a time-delay fuse or time-delay circuit
breaker is recommended.
All wiring must comply with local and national
electrical codes and be installed by a qualified
electrician. If you have any questions, contact
Q qualified electrician.
Electrical Requirements
A
warning
■ ^1
ELECTRIC SHOCK HAZARD
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Power Supply Cord
NOTE: Your unit's device may differ from the one shown.
B
This room air corxJitioner is equipped with a power suppt/ cord required
by UL. This power supply cord contairs state-of-the-art electronics that
sense le^age currant. If the cord is crushed, the electronics detect leakage
current ar>d power will be disconrrected in a fraction of a second.
To test your power supply cord:
1. Plug power supply cord mto a grounded 3-prong outlet.
2. Press RESET.
3. Press TEST (listen (or click; Reset button wil trip and pop out).
4. Press and release RESET Qisten for dick; Reset button will latch
and remain M}.The power supply cord is ready for operation.
NOTES:
* The Reset button must be pushed in for proper operation.
* The power suppfy cord must be replaced if It fails to trip when the
test button is pressed or fails to rest.
* Do not use the power supply cord as as an otr/on switch. The
power supply cord is designed as a protective device.
* A damaged power supply cord must be replaced with a new power
supply cord obtained from the product manufacturer and must r>ot
be repaired.
* The power supply cord contains no use senriceable parts. Opening
the tamper-resistant case voids all wan-anty and performance dsims.
INSTALLATION INSTRUCTIONS
Unpack the Air Conditioner
A
warimiimg
EXCESSIVE WEIGHT HAZARD
Use two or more people to move and
install air conditioner.
Failure to do so can result in back or
other injury.
Remove packaging materials
• Remove and prc^erly dispose of packaging materials.
Remove tape and glue residue from surfaces before
turning on the air conditioner. Rub a small amount
of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your air conditioner.
• Handle air conditioner with care.
e