Aiwa NSX-A10 - Manual (Page 6)

ADJUSTING THE SOUND MANUAL TUNING
VOLUME
VOLUME CONTROL
Turn the VOLUME control on the main unit, or press the
VOLUME buttons on the remote control.
The volume level is displayed as a number from 0 to MAX (31).
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
1^+1- -+2-$-i-3^oFF (cancel)
ROCK FOR ,IA77
■ I
' _!
To select with the remote control
Press the T-BASS button while pressing the SHIFT button.
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
GRAPHIC EQUALIZER
This unit provides the following three different equalization curves.
ROCK; Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ: Accented lower frequencies for jazz-type music.
Press one of the graphic equalizer buttons.
J i I / I Ì /
j ! I i'\
To cancel the selected mode
Press the selected button again. “EQ oFF” is displayed.
To select with the remote control
Press the GEQ button repeatedly while pressing the SHIFT
button.The GEQ mode is displayed cyclically as follows.
c:
ROCK- POP- JAZZ EQoFF —I
(cancel) I
> o o t j
• oa
MONO
TUNER
BAND
SHIFT
Press the TUNER/BAND button repeatedly to
select the desired band, FM or AM.
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
To select a band with the remote control
Press the BAND button while pressing the SHIFT button.
Press the DOWN or UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed.
During FM stereo reception, ((i<33)il) is displayed.
TUNE
I
' I I
i\ I i
I V r 11
To search for a station quickly (Auto Search)
Keep the DOWN or UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the DOWN or
UP button.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button while pressing the SHIFT button
on the remote control to extinguish AUTO in the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, ail preset stations (see
“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
Sound adjustment during recording
The output volume and tone of the speakers or headphones
may be freely varied without affecting the level of the recording.
ENGLISH