ADLINK PCI-9846 - Manual (Page 33)

Getting Started 23
2.4 Installing the module
To install the PXI-9816/PXI-9826/PXI-9846 module:
1. Turn off the PXI system/chassis and disconnect the
power plug from the power source.
2. Align the module’s edge with the card guide in the PXI
chassis.
3. Slide the module into the chassis, until resistance is felt
from the PXI connector.
4. Push the ejector upwards and fully insert the module into
the chassis.
5. Once inserted, a “click” can be heard from the ejector
latch.
6. Tighten the screw on the front panel.
7. Power on the PXI system/chassis.
To remove the module, reverse step 2 through 6 above.
To install the PCI-9816/PCI-9826/PCI-9846 module:
1. Turn off your computer
2. Remove the top cover of your computer
3. Select an available PCI slot and remove the bracket-
retaining screw and the bracket cover.
4. Line up the PCI digitizer with the PCI slot on the back
panel. Slowly push down on the top of the PCI digitizer
until its card-edge connector is resting on the slot recep-
tacle.
5. Reinstall the bracket-retaining screw to secure the PCI
digitizer to the back panel rail.
6. Restore the computer cover.