ADLINK aTCA-N700 - Manual (Page 14)

aTCA-RN720 User's Guide
14
Figure 4-2 Header J15
4.1.2 DIP Switches
SW1 is provided for MMC to select different I/O connection between ISP interface and UART
interface during debugging phase.
• MMC to UART: Close pin 1 and pin2.
• MMC to ISP interface: Open pin 1 and pin2
4.2 Hardware Installation
The steps required to install the aTCA-RN720 are the following: Front Blade installation, RTM
plugging-in, Monitoring Station Connection, and Traffic Port connection.
4.2.1 Front Blade
For front blade installation, refer to the front blade user's manual.
4.2.2 RTM
The board should be plugged in as the following procedures:
Step 1: The injector handles (top and bottom) shown in Figure 4-3should be opened to plug
the board into a chassis slot.
Step 2: The board should be aligned on to the rail (marked as (A)) in the reserved slot for the
board
Step 3: Slide the board into the chassis until the guide of the faceplate and the hole of the
chassis meet as in (B)
Step 4: Once the guide of the faceplate slides into the hole, close the upper injector handle so
that the handle wedge goes into the handle hole and makes a click sound.