ADLINK cPCI-3510 Series - Manual (Page 140)

126 IPMI User Guide
OemRescanGaInput
This command is used to rescan the geo-address input pins and
reset the IPMB address according to the input value.
OemTestFunction
Internal test purposes only.
OemReportGeoAddress
This command can report the IPMB address, the GA pin input sta-
tus, and the event forwarding control value.
OemEnableSmbus
This command is used to turn on the I2C bus when it is off during
boot up process. Usually BIOS will perform this command after
booting in boards with ServerWorks chipset.
Action Byte Value Description
Request
0 C0h NetFn/LUN for OEM
1 22h OEM defined command
Response
0 Complete Code 00h means OK
1 New IPMB address New IPMB address value
Action Byte Value Description
Request
0 C0h NetFn/LUN for OEM
1 F0h OEM defined command
Response
0 Complete Code 00h means OK
1 IPMB address IPMB address value
2 GA value GA pin input status
3 Control value Current control value of event forwarding
Action Byte Value Description
Request
0 C0h NetFn/LUN for OEM
1 F2h OEM defined command
Response 0 Complete Code 00h means OK