ADLINK cPCI-3510 Series - Manual (Page 21)

Specifications 7
cPCI-3510
2 Specifications
2.1 cPCI-3510 Processor Blade Specifications
CompactPCI®
Standards • PICMG® 2.0 CompactPCI® Rev. 3.0
• PICMG® 2.1 Hot Swap Specification Rev. 2.0
• PICMG® 2.9 System Management Rev. 1.0
• PICMG® 2.30 CompactPCI® PlusIO
Mechanical • Standard 3U CompactPCI®
• Board size: 100mm x 160mm
• Single slot (4HP, 20.32mm); Dual slot (8HP, 40.64mm);
Triple-slot (12HP, 60.96 mm)
• CompactPCI® with HM type J1 connector, UHM type J2
connector
Processor • Intel® Core™ i7-4700EQ Processor, 2.4 GHz, 6MB LLC
cache, TDP 45W
• Passive heatsink
Chipset • Mobile Intel® QM87 Express Chipset
Memory • Dual channel DDR3L-1600 ECC soldered memory
• Up to 8GB
CompactPCI
Bus • PCI 32bit/ 33MHz; 3.3V, 5V universal V I/O
• Supports operation in system slot as master or in peripheral
slot as standalone blade without connectivity to CompactPCI
bus (Satellite mode)
Gigabit
Ethernet • One PCIe x1 Intel® I217 GbE PHY and three PCIe x1 Intel®
I210 Gigabit Ethernet controllers
• Two egress 10/100/1000BASE-T ports on front panel, one
supporting Intel® AMT 9.0 by I217 controller
• Two egress 10/100/1000BASE-T ports routed to rear
transition module
Graphics • Integrated on Intel® Core™ processor
• DVI-I port on front panel, VGA switchable to J2 (RTM) by
BIOS setting
• Analog monitor support up to QXGA 2048x1536 @75Hz,
32-bit
• Two DisplayPorts on front panel with resolution up to
2560x1600 @60Hz (cPCI-3510G only)
• Up to three independent display
USB • Up to three USB front panel ports
Table 2-1: cPCI-3510 Processor Blade Specifications