ADLINK cPCI-3971 - Manual (Page 150)

136 IPMI User Guide
System Power Status
This command is used to detect system power status via GPIO pin
signal on IPMC chip.
BIOS Operation Status
This command is used to get BIOS operation status. Related sta-
tus is provided by BIO.
Action Byte Value Description
Request
0 18h NetFn/LUN
1 5Bh Defined command
Response
0 Complete Code 00h means OK
1 00h~01h
00: Power Fail
01 : Power OK
Action Byte Value Description
Request
0 18h NetFn/LUN
1 5Ch Defined command
Response
0 Complete Code 00h means OK
1 00h~07h
00 : Not Ready.
01 : BIOS Reset.
02 : ROM Check.
03 : Initiate Hardware.
04 : Enter BIOS Menu.
05 : Start BIOS firmware
burning process.
06 : Complete BIOS
firmware burning process.
07 : POST OK