Advanced Control Technologies Specs Instructions ZTW103I (RF 120 VAC, Wall Transmitter,908.42MHz, Ivory) - Manual

ZTW103 Advanced Instructions, Release 1.1
P/D 102406
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0728-01
1
Radio Frequency Controlled, 120 VAC,
Wall Mounted 3-Way Transmitter, Release 1.1
ZTW103
ZTW103 WALL MOUNTED TRANSMITTER
The ZTW103 Wall Mounted Transmitter is a component of the HomePro lighting control system. As it controls
no load directly, wire the Transmitter anywhere power is available according to the diagram above and program
from the Wireless Controller to operate loads. Inclusion of the ZTW103 Wall Mounted Transmitter on the ZTH100
Wireless Controller menu allows remote ON/OFF control and dimming of lights controlled by associated modules.
This Wall Mounted Transmitter is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other
types can be Included in the network and will also act as repeaters to increase the range of the network.
There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where
purchased.
INSTALLATION
DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended
for installation in accordance with the National Electric code and local regulations in the United States, or the Canadian
Electrical Code and local regulations in Canada. It is recommended that a qualified electrician perform this installation.
Retain instructions for future use.
With power off, wire this ZTW103 and AS101’s (if used) according to the diagram shown above. AS101’s are
required to be wired to the same line (or neutral) which is also wired to the master unit as well as the load being
controlled, and not wired to any other neutral. If multiple neutral’s are tied together in one box separate the neutral’s
to preserve the integrity of the ZTW103 circuit. If more than one ZTW103 is to be installed in a wall box, scored
tabs on the side can be broken off by bending back and forth with pliers, to accommodate proper fit. Apply power
when completed.
Refer to your Controller operating instructions for instructions on how to include this module in the RF network.
HomePro
RF Home Automation
Supplied with decorative
switch plate
Note: This module must be “Included in the
Network” only where it will be permanently
installed. The proper operation of this node in the
mesh network is dependent on it knowing its
location with respect to other nodes. You cannot
“test bench” configure this module.