Advanced Control Technologies Specs Instructions ZTW103I (RF 120 VAC, Wall Transmitter,908.42MHz, Ivory) - Manual (Page 2)

ZTW103 Advanced Instructions, Release 1.1
P/D 102406 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0728-01
2
INCLUDING ZTW103 TO THE NETWORK
Including to the Network
1. Setup the controller you are using to include a device into network.
2. Tap either the top or bottom of the paddle once
Excluding from the Network
1. Setup the controller you are using to exclude a device from the network.
2. Tap either the top or the bottom of the paddle once.
OPERATION
Before you can control Z-Wave devices you must associate the devices you want to control into the ZTW103.
Turning Z-Wave devices On or Off
1. Tap the top of the paddle to turn On Z-Wave devices.
2. Tap the bottom of the paddle to turn Off Z-Wave devices.
The LED on the ZTW103 will indicate the status of the devices you are controlling. The LED on the ZTW103 will
flicker when it is transmitting commands to any of the four groups. This can be changed. See “LED Transmis-
sion Indication”.
Dimming and Brightening
1. Press and hold the top of the paddle to brighten Z-Wave enabled dimmers.
2. Press and hold the bottom of the paddle to dim Z-Wave enabled dimmers.
Associating Z-Wave devices you want to control into the ZTW103
Refer to your controllers instructions to find out how to associate Z-Wave devices
You can associate another Z-Wave device into any or all of the 4 available groups in the ZTW103. The four
groups are described below:
Group 1
Nodes in this group are turned ON by tapping the top of the paddle or OFF by tapping the bottom of the
paddle.
Nodes associated into this group are dimmed by pressing and holding the bottom of the paddle until the
desired dim level is reached or brightened by pressing and holding the top of the paddle until the desire level
is reached.
The LED on the ZTW103 will indicate the status of this group ONLY.
Note that associating nodes into group 2 or 3 will cause a very slight delay before the command is transmitted to group 1.
Group 2
Nodes in this group are turned ON by tapping the top of the paddle twice or OFF by tapping the bottom of the
paddle twice.
Nodes associated into this group are dimmed by tapping the bottom of the paddle once and then pressing and
holding the bottom of the paddle until the desired dim level is reached or brightened by tapping the top of the
paddle once then pressing and holding the top of the paddle until the desire level is reached..
Group 3
Nodes in this group are turned ON by tapping the top of the paddle three times or OFF by tapping the bottom
of the paddle three times. Nodes associated into this group are dimmed by tapping the bottom of the paddle
twice and then pressing and holding the bottom of the paddle until the desired dim level is reached or bright-
ened by tapping the top of the paddle twice then pressing and holding the top of the paddle until the desire
level is reached..
Group 4
Nodes in this group are turned ON or OFF or set to a specific dim level when the ZTW103 is controlled
remotely.
You can place up to 5 nodes in each group.
If controlling dimmers, for best results, associate the dimmers into the group first.