Install & connect the dsd4121 decoder – Altech UEC DSD4121RV User Manual
Page 5
Page 4 of 22
QUICK START GUIDE FOR EXISTING AURORA INSTALLATIONS
Remove decoder from packaging.
Insert supplied batteries into the remote control.
Connect to existing TV and dish installation - verify the LNB setup in the menus and adjust and re-scan if
necessary.
Decoder should lock to service and present video.
QUICK START GUIDE FOR NEW INSTALLATIONS
Ensure that all connections are secure before connecting the power cable (#11)to the power input connector.
Option A: AV Connectors (Standard Definition TV)
Connect the satellite feed to the SAT IN input (#1) on the decoder.
Connect the Audio / Video cables to the audio (#6) and video (#8) outputs on the decoder and then to
the audio and video inputs on the TV or home theater system.
Option B: HDMI Connector (High Definition TV)
Connect the satellite feed to the SAT IN input (#1) on the decoder.
Connect a High Definition cable to the HDMI connector (#9), and then connect the other end of the
cable to the HDMI connector on the TV.
Option C: HDMI Connector (AV Home Theater system and a High Definition TV)
Connect the satellite feed to the SAT IN input (#1) on the decoder.
Connect a High Definition cable to the HDMI connector (#9), and then connect the other end of the
cable to the HDMI input connector of the AV home theater system. Then connect the output HDMI of
the AV home theater system to the TV.
1
2
INSTALL & CONNECT THE DSD4121 DECODER
Install & Connect the DSD 4121 Decoder
8
1
6
9
11
CONNECTING THE DSD4121 DECODER