Ambir ImageScan Pro 940u - Manual (Page 10)

Ambir ImageScan Pro
TM
940u Quick Start Guide
10
Calibrate the scanner if colors appear in areas that should be white,
or colors of the scanned image and the original vary a lot. This allows
you to adjust and compensate for variations that can occur in the optical
component over time by its nature.
The following describes how to calibrate the scanner:
1. The included Calibration Sheet, marked with an arrow on either edge at
both sides, is used specifi cally for calibrating the ImageScan Pro 940u.
2. Insert the special Calibration Sheet into the ADF of the scanner, with the
arrow pointed toward the scanner buttons.
3. Click Start > All Programs > Your scanner model name > Calibration
Wizard.
4. Click Next from the Calibration Wizard that pops up, then click Calibrate
Now....
5. Click on the Start button to begin the calibration process.
6. The scanner pulls the calibration sheet through the scanner, which
completes thecalibration process. After the calibration is complete, click
OK and then click Finish.
Calibration
Cleaning the ADF
1. Open the ADF cover by pulling the lever.
2. Gently wipe the following areas with the cloth dampened with
the cleaner. Be careful NOT to scratch their surfaces.
Clean Feed Roller:
Wipe the Feed Roller from side to side and then rotate it. Repeat
this until its entire surface is cleaned.
Clean Pad Module:
Wipe the Pad Module from top to bottom (in the direction of
arrow shown in below picture). Be careful not to damage the
pick springs of the pad.
3. Wait for cleaned areas to dry completely.
4. Close the ADF cover by pushing it back down until it snaps
back into place.
TM
Have the following cleaning materials ready to clean the scanner:
soft, dry, lint-free cloth
DO NOT USE WATER
non-abrasive cleaner fl uid: Isopropyl
rubbing alcohol(95%)