Angelcare AC1100 - Manual (Page 13)

6.10 - zOOM MODE
Allows you to zoom in to twice the normal view.
1 2 1) Press the zoom icon.
2) Press the directional arrows to zoom in
on what you want to see more closely.
3) Press the zoom icon again to return
to normal view.
6.12 - KEY TONE
Allows you to activated or deactivate key tone sound.
1) Press the Menu icon to access
main menu.
2) Press the settings icon
to access sub-menu.
3) Press icon to activate or deactivate
key tone sound.
4) Press OK icon to confirm. ON OFF
ON OFF
3
1
OK
2
OK
OFF
ON
ON
3
6.13 - TIMER
Attain activities.
1) Press Menu icon to access
main menu.
2) Press Timer icon
to start or stop the timer.
3) View Timer in video mode.
(shows in minutes only).
• Stops automatically after 5 hrs 59 min.
• Stops automatically if the Parent Unit
is turned OFF. ON OFF
1
OK
2
0:00
3
6.11 - MUTE
Allows you to put your monitor in Silent/Mute mode
TO PUT ON MUTE:
Press the (-) button and hold
for 2 seconds to mute sound.
TO UNMUTE:
Press the (-) button again and hold
for 2 seconds to unmute sound.
NOTE:
On the Parent Unit,
the Mute ICON will blink
.
TROUBLESHOOTING
TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 10 hrs before their first use.
• To maintain maximum battery life it is recommended that you fully discharge your
batteries periodically. Battery performance can be diminished by leaving the batteries
constantly charging on the charging cradle. If your Parent Unit is no in use, please turn
it off.
• Inadequate battery power can impair the performance of your monitor. If you are
not happy with the performance of your Parent Unit/Monitor, please replace the
rechargeable batteries (3 x NIMH Rechargeable batteries).
• It is advisable to change the batteries every 6 months.
FALSE ALARMS
• Turn OFF the Nursery Unit.
• Verify the connection between Sensor Pad and Nursery Unit. Unplug and reconnect
the cord.
• Make sure there is no bedding between mattress and Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 33 x 33 cm and 6 mm thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to step 5.1.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is ON.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the crib.
• You may need to decrease the sensitivity, refer to step 5.1.
NO SOUND IS BEING TRANSMITTED
• Bring Parent Unit closer to Nursery Unit.
• Check/replace batteries or recharge Parent Unit.
• Check connections or change to another electrical outlet.
• Ensure both units are ON.
• Ensure mains supply units are activated.
• Check on the top bar of the Parent Unit to see if the Monitor is on “MUTE” instead
of “ON”. Refer to step 6.11.
NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check connections or change to another electrical outlet.
• Push and hold the left ‘wing’ for 2 seconds to turn the Nursery Unit ON.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby’s reach.
• Replace the batteries or recharge Parent Unit.
25 24