Angelcare AC1100 User Manual
Page 8
STEP 4 - TURNING ON YOUR MONITOR
OK
4
2
1) Press the Parent Unit ON/OFF button
for 2 seconds until blue screen appears.
2) The Parent Unit will display
Video mode screen.
3) Press the Menu icon to access
main menu.
4) The Parent Unit will display
Menu mode.
5) Push and hold the Nursery Unit left
‘wing’ button for 2 seconds.
Temperature icon:
Indicates room temperature
Temperature Alarm icon: Indicates
Temperature Alarm is active
Pendulum icon: Indicates the
Motion Sensor is active
Sound icon: Indicates that Sound
function is active
Alarm icon: Indicates selected
alarm mode
Sound alarm
Sound alarm
and vibration
Vibration only
INDICATION BAR IMPORTANT ICONS
Connection icon: Indicates the
connection quality between the
Parent Unit and Nursery Unit.
Good connection
Poor connection
Lost connection
Out-of-Range
Battery Level icon:
Indicates battery level
Empty
1/3 Full
2/3 Full
Full
3
1
5
When Parent Unit is turned ON and
Nursery Unit is OFF, Parent Unit will
display Disconnected Mode and will
turn itself OFF after 60 seconds.
If there is a lost connection
between the 2 units (refer to
troubleshooting):
• The Out-of-Range icon will
appear on the screen.
• The Lost Connection icon will
appear on the indicator bar.
5.1 - SENSOR PAD
1) Press Menu icon to access
main menu.
2) Press Movement icon to activate
or
deactivate Movement Alarm.
3) Press OK icon to confirm.
1) Move your hand lightly on the mattress.
The pendulum icon will appear
on Parent Unit indicator bar.
It will move as you move your
hand and trigger a ‘TIC’ sound.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
‘TIC’ pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
• Adjust Sensor Pad sensitivity level.
ON
OFF
1
2
TO ACTIVATE THE SENSOR PAD:
TO TEST THE SENSOR PAD:
MOTION ALARM
• Alarm activates when no movement is detected by Sensor Pad for 20 seconds.
• Both the Parent Unit and Nursery Unit speakers will emit loud warning sound.
• Motion Alarm icon will show on the LCD screen.
1
OK
2
STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR
IMPORTANT
When in menu or sub-menu modes,
sound transmission between Parent
and Nursery Units will be temporarily
deactivated. ONLY movement-
detection alarm will remain active (if
function is activated).
OK
All changes and
adjustments made
in the main menu and
sub-menus will not be
activated unless you
confirm them by pressing
the
OK icon.
The Angelcare
®
monitor can be used with the pre-program factory settings or you can
also customise your settings to your preference.
15
14