Angelcare AC1100 - Manual (Page 6)

STEP 2 - INSTALLING THE SENSOR PAD
WARNING
STRANGULATION HAzARD.
Children have STRANGLED in cords:
• Keep adapter cords out of the reach of children
(more than 1 m away).
• Because of the serious strangulation risk to infants
and toddlers, parents and caregivers should never
place the Nursery Unit within 1 meter of a crib.
• NEVER use Sensor Pad without the cord covers.
Check cord covers before each use to ensure it is
securely placed under the leg of the crib. Discontinue
use of Sensor Pad if any cord covers are damaged or
broken.
• NEVER use extension cords with AC adapters. ONLY
use the AC adapters provided. This product is not a
toy. Never allow children to play with it.
6
5
4 3 2 1
Keep
at least
1 m.
IMPORTANT
6 5 4 3 2 1 Cord covers 1, 2, 3, 4:
Position on floor
Cord cover 4:
Contains double sided
tape to securely install
beneath crib leg
Cord cover 5:
Position vertically
between mattress
support and floor
Cord cover 6:
Place under
the mattress
Sensor Pad with pre-installed cord covers
2.1 - SELECT A LOCATION FOR THE NURSERY UNIT
Select a location for the Nursery Unit that is
at least
1 meter away from the crib.
6
5
4
3
2
1
6
5
4
3
2
1
Fig 1
Fig 2
1) Use the crib leg by the wall closest to
the Nursery Unit (fig 1). In cases where
the Nursery Unit is across the room, use
the leg closest to the Nursery Unit to
position the covered wire
(fig 2). It is
always preferable that the covered cord
run along a wall.
2.2 - SELECT THE CRIB LEG YOU WILL BE USING TO SECURE THE CORD COVERS
RECOMMENDED
1) Remove the mattress from the crib.
2) Place the Sensor Pad - printed side up
- on top of the hardboard at the center
of the crib.
3) Run the connection pin, warning label
and the first 5 cord covers down along
the backside of the crib leg,
between
the mattress support and the inside
edge of the crib.
4) Bring the first 4 cord covers down
the floor, and keep the 5 th cord cover
vertically, along the backside of the crib
leg,
(between the mattress and the
inside edge of the crib).
5) Remove any cord slack to make sure
no parts of the cord are loose.
3
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
6
5
4
3
1
2
OR
4
5
5
11 10