AutoPage C3-RS1100 OLED - Manual (Page 16)

Aug/2009
C3 RS-1000 OP 16
Here’s how the “Noise Abatement Circuit” works: If the alarm triggers five times, each time the same sensor
(zone 4) is triggered the “Noise Abatement Circuit” will interpret this pattern of triggers as false alarms. After
the fifth trigger, the “Noise Abatement Circuit” ignores, or bypasses that sensor until any other sensor or
switch is triggered.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door for
six full cycles, the doors will be bypassed until the trigger ceases.
M. ANTI CAR - JACKING
Warning: If you don't need the car jacking function in this alarm system, be sure to set car jacking feature
“OFF”. This system is default setting all car-jacking “OFF”.
ACTIVE ANTI CAR JACKING:
1. Spin up the switch to the page 1 and then press and hold the “Car Jacking” button
for 2 seconds or press and hold the transmitter and buttons at the same time
for 2 seconds while the vehicle’s ignition is ON. The parking lights will turn on for 1.5
seconds to indicate the system has entered the car-jacking mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will be triggered when the door is opened and closed while the ignition is in
the “ON” position.
PASSIVE ANTI CAR- JACKING: (Programmable)
1. Turn the ignition switch to the “ON” position. The system enters the car-jacking
mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will trigger when the door is opened and closed while the ignition is in the
“ON” position.
TRIGGER THE ANTI CAR -JACKING MODE:
a). 50 seconds after the system has beer triggered. The siren will start chirping for 15 seconds.
b). During this 15 seconds period of chirping, you will be alerting to push the valet switch once to turn off the
car-jacking feature. If not, it will enter second timer car jacking.
c). 65 seconds after the system has beer triggered. The siren starts alarming and the parking light starts
flashing. (Forced engine shutdown mode is activated (if installed), the vehicle will slowly shutdown within
25 seconds.)
d). 90 seconds after the system has beer triggered
1. The siren still alarming and the parking light flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and the
system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
N. SYSTEM’S TRIGGER CHECK
Spin up the switch to the page 4 and then press the “Trigger
Check” button. The remote will respond with one melody sound and
all trigger records will immediately be displayed on the OLED
screen.
Note: It will display the homepage if there were no system’s
triggered.
O. SYSTEM’S STATUS CHECK
Spin up the switch to the page 4 and then press the “Status
Check” button. The remote will respond with one melody sound and
the vehicles status will immediately be displayed on the OLED
screen.
Note: It will display the home page if the car’s status is normal.
P. DRIVER PAGING / LOSE & FOUND
It is useful the event that someone wants to page the driver of the parked vehicle or someone cannot find his
OLED remote transceiver.