Bonaire Ultracooler - Manual (Page 11)

9
Maintenance - Mantenimiento
Daily maintenance on your COOLER is required. At the end of each day run your COOLER on fan
only for 30 minutes to dry out filter. Regular maintenance is essential if your COOLER is to operate
at peak efficiency. It is recommended that two to three times during the summer you drain the unit
and clean the filter.
! WARNING ! This is an electrical appliance. Stop the unit and disconnect the plug from
the power point before doing any maintenance .
1. Remove the rear panel by inserting a screw driver or similar tool into the slotted ‘clip release
area’ at the top rear of the unit, then lift the screw driver in an upwards fashion, the clip will
disengage, repeat for each of the three clips and lift out the panel.
2. To drain the unit, remove the drain plug. Ensure that the bucket is placed under the unit to
catch the water.
3. To clean the filter, hose the filter and rear panel assembly from the inside until the run of water
is clear. This will remove any accumulated dust which would otherwise impair the cooling
efficiency of the unit. Ensure filter pad is dry prior to packing away unit for winter.
4. Replace the drain plug into the tank and replace the rear panel.
NOTE: The filter over two seasons may become dust laden and result in reduced performance.
When this occurs the filter should be replaced so that the summer comfort is maintained.
To remove the filter from the rear panel simply unclip the retaining grille and discard the old filter.
Ensure the filter is properly located on the rear panel so that there are no gaps around the edges.
Replace the retaining grille and put the rear panel back onto the unit.