Bonaire Ultracooler - Manual (Page 7)

6
1. Remove the components from the packing -
screws, base, post parts and castors, and then
set them to one side.
2. Hold the two post halves together and place them
on a table on something soft with the flange
overhanging the edge of the table. Using the
palms of your hand apply even pressure along
one edge, then the other until the clips snap shut.
3. Place the assembled post on a flat surface (flange
down). Locate the central recess in the base over
the post and push down until the clips engage.
Take care that your fingers are clear of the gap
between the two halves when clipping together.
! WARNING ! Please dispose of the plastic bag
carefully. It could be a suffocation risk for
young children.
4. Push the castors into their mounting bushes until
they click.
5. Carefully lay your COOLER on a bench or table,
with the bottom of the cabinet to prevent
damage. Line the post up with the depression in
the bottom of the tank, then insert the screws
supplied and firmly tighten. You will require a flat-
headed screwdriver to insert the screws.
6. Gently place your COOLER unit on the floor and
wheel it into position near an open window or
door (see section 4 for location
details).
POST BASE
6
1
2
3
4
5
Assembly - Asemble