Bonaire Deluxe Control (LV) - PNE - Manual (Page 8)

Manual Comfort Control
Operating the Controls
PNE2002 Series Control Page 8
Operating the Controls
Control Functions
The MANUAL control is a simple low voltage controller that allows you to operate each function of the
product as required to keep you home cool. As there is no thermostat in the Manual control it can be
located anywhere that is convenient to the customer and the installer.
To use the control you will need to turn the fan ON, or the fan and cool switches ON to operate .
Using the Fan Mode
Using the fan mode on the Manual control the unit will
operate the fan only providing ventilation in the building.
1. To activate the room air fan, turn the Fan ON / OFF
switch on by toggling the switch to the right.
2. To adjust the speed of the fan, rotate the Fan
Speed control knob. Clockwise will increase
the air and anti-clockwise will decrease the air.
Your product is fitted with a variable speed fan
motor and therefore can be adjusted to your desired
level of air.
3. To turn the fan OFF toggle the Fan ON / OFF switch to
the left. The fan will now stop.
Using the Cool Mode
Using the cool mode introduces the pump. When the pump is turned ON water will be pumped around
the water distribution system saturating the filter pads.
1. To activate the pump, turn the Cool ON/OFF switch on by toggling the switch to the right. The
pump will now pump water around the water distributor saturating the filter pads.
2. To turn the pump OFF, toggle the Cool switch to the left and the pump will stop.
Pre-Cool
As the Manual control does not have a pre-cool function, this can be simulated by:
1. Turn ON the Cool switch first and allow the pump to operate for 3 to 5 minutes. This will allow the
filter pads to be saturated with water before the fan starts.
2. After the 3 to 5 minutes is complete, turn ON the Fan switch. The unit will deliver cool fresh air with
in seconds of the fan starting.
If you do not wish to wait for the pre-cool period, the fan can be turned on at the same time as the pump
and the air will eventually become cool as the filters saturate.
NOTE: Normally during the first 10 days of operation a slight odor will be present from the CELDEK filter
pads. This 'new smell' is quite normal, and will quickly disappear as your unit is operated.