Chicago Gaming Arcade Legends - Manual (Page 3)

2. GAME SETUP
2.1 PRE-GAME INSTALLATION
Remove the game from the shipping container. Included with the game; is an envelope
containing the game keys, SYSTEM INSTALL CD, and this manual. Connect the wall
cord to a grounded (3-terminal) AC wall outlet. The following precautions should be
followed when installing the game:
• Avoid rough handling of the game; the picture tube is fragile.
• Install the game on a level surface.
• Avoid installing the game where it will receive excessive sunlight or heat,
to protect the game from rising internal temperatures.
• Do not install in a damp or dusty location.
• For a short time after connecting the power to the game, the picture may
be temporarily distorted.
The monitor’s purity is affected by the Earth’s magnetic field, causing a variation
of color. By turning the game on for 10 or 15 seconds and then off for 20 or 30 minutes
the automatic degaussing circuit applies a degaussing field around the edges of the
monitor. Doing this a number of times will correct the problem.
Another way to correct the problem is to purchase a degaussing coil or bulk tape
eraser at any electronics store. This will help to immediately demagnetize the video tube.
Caution must be used with a degaussing coil so that the magnetic field of the degaussing
coil is not allowed to become too intense at any one place on the picture tube, thereby
causing a localized color distortion.
If you move the game to another location after degaussing the distortion may
reappear. Refer to the video monitor manual for details.
The game monitor is properly adjusted before shipping. If there are any
adjustments necessary, refer to the video monitor manual. This manual contains all the
manufacturer recommendations for adjusting the video monitor.
Primary monitor adjustments are located behind the faux coin door.
2.2 ON / OFF SWITCH
The On/Off switch is located on the top of the machine in the back right
hand corner.