Chicago Gaming Nicktoons Nitro - Manual (Page 6)

Nicktoons Nitro • Copyright 2008 • Raw Thrills • All rights reserved .
6
Seat Assembly Procedure
WARNING: The cabinet is top heavy. Install only on level surface. Use the leg levelers to make sure the cabinet and seat
are stable. Do not push against plastic parts during movement.
1. Roll the cabinet and seat to the intended location and lower the leg levelers until both are equal height and stable.
2. Locate the [2] Base Connect Boards, [1] Seat Base Extension, [8] ¼-20 x 1 ¼” Hex Head Bolts (Longer) and
[8] ¼” Flat Washers included. The Seat Base Extension is used to move the seat base back to allow for more
room. See step 7 for information on connecting it.
3. If you ARE using the Seat Base Extension to move the seat back, you will mount the Base Connect Boards
using the set of mounting holes furthest from the T-Nuts, making the boards longer.
4. If you ARE NOT using the Seat Base Extension, you will mount the Base Connect Boards using the set of
mounting holes toward the middle, making the boards shorter.
5. Facing the cabinet, fasten the board to the inside RIGHT of the CABINET with bolts until finger tight; some
movement is required in the mounting boards to align holes with seat pedestal assembly. Use the appropriate
mounting holes on the board and make sure the screws holding the T-Nut in place are facing IN.
6. Facing the seat base, fasten the board to the inside RIGHT of the SEAT BASE with bolts until finger tight; some
movement is required in the mounting boards to align holes with seat base assembly. Use the appropriate
mounting holes on the board and make sure the screws holding the T-Nut in place are facing IN.
7. If you are using the Seat Base Extension, place it over the cabinet Base Connect Board and pull the wiring
harness through. When you push the cabinets together, both base connect boards should pass through the
center. If you are not using the seat base extension, skip to step 8.
8. Roll the seat base near the cabinet and align the ends of the boards with the openings in the cabinet and seat
base. Slide the seat base forward so each board enters the other opening, leaving enough space to attach the
wiring harness. Mate each cable connector and press firmly to seat the contacts. Ensure no wires are pinched
during the seat base attachment.
9. Fasten in place with the ¼-20 x 1 ¼” hex head bolts (Longer) and ¼” flat washers provided.
10. Adjust all levelers until both cabinet and seat are flush and parallel with each other. Inspect for pinched wires
before firmly tightening the remaining fasteners to attach the two pieces as one.
Cabinet Seat Base
Using Seat Base Extension Not Using Seat Base Extension T-Nuts
Base Connect Board