Chicago Gaming Nicktoons Nitro - Manual (Page 7)

Nicktoons Nitro • Copyright 2008 • Raw Thrills • All rights reserved .
7
Setting Up Marquee
1. After connecting the seat pedestal and lowering leg levelers, move the marquee into the upright position.
2. Locate the two marquee support brackets. Use the four ¼-20 x ½” black hex head bolts (Shorter) to mount the
brackets to the cabinet and back of the marquee.
Power Up Procedure
1. Plug the game line cord into an appropriately wired and fused AC receptacle.
2. Locate the game AC main switch to the bottom right side on back of the game cabinet.
3. Turn the switch to the ON position.
4. The game attract feature will begin after the game is finished loading- approximately 30 seconds.
5. Proceed to Switch Test of this document and verify proper game operation.
Game Networking
NOTICE: To link the two games together, use the crossover cable provided in the spare parts bag. Use of another cable
other than the one shipped with the game could void warranty or cause games not to link. Use network cables that are at
least CAT5 grade.
Networking Considerations
Each Nicktoons Nitro game comes with a network cable. Optionally, a hub can be installed and located remotely to
monitor network activity.
Take care to protect exposed game wiring from general foot traffic around the game. Use a conduit or wire way to protect
the cables as needed.
Please mark linking cables for your game if other such cables are in the vicinity to avoid confusion. Network cables are
not marked or coded.
Avoid routing the network cables near sources of heat, moisture or electrical energy such as neon lights, compressor
motors, transformers etc.
Networking Setup
1. Remove the network cable from the spare parts bag inside the cashbox.
2. Connect each end of the cable to network jack behind each PC.
3. Neatly route the cable through the notch on the back of the cabinet.
4. Use the DIP switch diagram below for enabling link feature and master/slave configuration. The DIP switch is located
on the JAMMA I/O board. The JAMMA I/O board is mounted inside the back of the cabinet.
DIP SWITCH DIAGRAM:
DIP SW# SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
Player ID 1 OFF OFF ON
Player ID 2 ON OFF ON
Player ID 3 OFF ON ON
Player ID 4 ON ON ON
5. Reset both games simultaneously and verify that link is successful. If not, check the DIP switch settings and make
sure that the network cable is connected properly and secured. Please refer to the Game Troubleshooting Guide in
this manual for more details.