Ditch Witch RT Line - Manual (Page 39)

Drive - 38
RT12/RT16/RT20/RT24 Operator’s Manual
Start Unit
CMW
Start Unit
1. Check that all controls are in neutral.
2. If necessary, use choke control to start cold engine.
3. Move throttle to 1/4 open.
RT12: Set throttle switch to low.
4. Turn ignition switch to START position to crank engine.
5. Release key when engine starts.
6. Run engine at half throttle or less for five minutes before operating trencher. During warm-up, check
that all controls work properly.
Explosion possible.
Using starting fluids will cause ignition in the intake manifold.
IMPORTANT: If engine does not start, turn ignition switch to OFF position and check for fuel
blockage or electrical system problems.
EMERGENCY SHUTDOWN: Release controls and turn ignition switch to OFF position.