Drill – Ditch Witch RT Line User Manual
Page 58
RT12/RT16/RT20/RT24 Operator’s Manual
Drill - 57
Drill
CMW
Drill
1.
Pull selector valve upward to select drill mode.
2.
Start engine and begin clockwise (forward) rotation.
3.
Slowly advance machine while maintaining clockwise rotation.
IMPORTANT: For location and description of drilling controls see “Control Console” on page 22.
EMERGENCY SHUTDOWN: Release all controls and turn ignition switch to OFF position.
NOTICE:
•
Drilling too quickly causes bit to drift off course and may bend drill rod. After bore path is
established, speed may be slightly increased.
•
If drill rod starts to bend, stop forward movement of unit and back the unit slightly until rod
straightens. Do not drill with bent rod.
•
If drill rod hits an obstruction, rotate drill string counterclockwise to back up slightly.