Echelon i.LON 10 Ethernet Adapter - Manual (Page 55)

domain varies and can be set by a network
tool such as the LonMaker tool.
Subnet/Node The L ON W ORKS address associated with the
i.LON 10 Ethernet Adapter. A network tool
such as the LonMaker tool sets this value.
Ethernet MAC The Ethernet MAC address of the i.LON 10
Ethernet Adapter.
Transmission Errors The number of CRC errors on the FT or LP
channel detected during packet reception
since the last reset.
Transmission Timeouts The number of times since the last reset that
the i.LON 10 Ethernet Adapter expected to
receive acknowledgements or responses but
did not. These may be due to inaccessible
devices, noise on the network, or insufficient
buffers on the destination device.
Receive Tx Full The number of times since the last reset that
an incoming packet was discarded because
there was no room in the i.LON 10 device’s
transaction buffer.
Lost Messages The number of times since the last reset that
an incoming packet was discarded because
there was no application buffer available.
Missed Messages The number of times since the last reset that
an incoming packet was discarded because
there was no network buffer available.
Network Routing The local and destination IP addresses, subnet
mask, gateway, interface, and packet count
since the last reset. The IP addresses, subnet
mask, and gateway can be can be set as
described in
Using the i.LON 10 Ethernet Adapter in
Chapter 3.
Viewing the i.LON 10 System Log Web Page
The i.LON 10 Ethernet Adapter System Log web page lists network events. This
web page is accessed by clicking the System Log link on the i.LON 10 Ethernet
Adapter web page. This web page appears as shown in the following figure:
i.LON 10 Ethernet Adapter User’s Guide 7-3