Echelon i.LON 10 Ethernet Adapter - Manual (Page 63)

Message Description
to dial out.
AUTOPPP: Incoming call
accepted This message indicates that the i.LON 10
has received the configured number of
rings and has issued an "ATA" command
to the modem to answer the call.
AUTOPPP: Two successive
attempts to 'xxx-xxxx'
resulted in answer but no
carrier (possibly voice)
AUTOPPP: The FCC requires
that no further attempts to
that number be made
These messages indicate that there were
two consecutive voice answers on the
phone number dialed. No further
attempts on this number are permitted.
These two messages will appear together.
AUTOPPP: Successive calls to
'xxx-xxxx' resulted in no
answer from the host"
AUTOPPP: The FCC allows no
more than 10 attempts per
hour -- number throttled
These messages indicate that there were
two consecutive unanswered or
uncompleted calls to the number. Due to
FCC regulations of a maximum of 10 calls
per hour to the same number, each
successive call to a number will be
delayed by an additional minute to a
maximum of 10 minutes between calls.
These two messages will appear together.
AUTOPPP: Shoulder Tap not
allowed due to FCC
regulations (two previous
voice calls)
AUTOPPP: The FCC requires
that no further attempts to
that number be made
These messages indicate that the i.LON
10 received a shoulder tap call but
detected two voice calls at this number
previously. FCC regulations prohibit the
i.LON 10 from dialing this number again.
These two messages will appear together.
PPP: connection has been
terminated
This message indicates that the PPP
session has been terminated. Note that a
reason may appear in parenthesis in the
same System Log message. This message
may include a reason in parenthesis,
described below.
PPP: could not establish
connection
This message indicates that the PPP
session was not established for some
reason. Note that a reason may appear in
parenthesis in the same System Log
message. This message may include a
reason in parenthesis, described below.
PPP: User id/Password not
accepted.
This message indicates that the PPP
session was not established for some
reason. Note that a reason may appear in
i.LON 10 Ethernet Adapter User’s Guide 7-11