Electrocompaniet ECT 3 - Manual (Page 8)

8
1.7 Using the ECT 3
3.Beep ON/OFF
Activate or deactivate the inbuilt buzzer by pressing on arrow left or
right on the control wheel. Press EXIT for previous page.
4.Power Mode – press arrow up or down for changing between:
Power down: adjust the release time for automatic standby for the
ECT 3 between 3 and 30 minutes
Press arrow left and right for changing the value.
Display Off – adjust the release time for automatic display off
between 20 and 180 seconds. Press arrow left and right for chang-
ing the value.
5. Connect
Press OK for activates a connection between the ECT3 and a RF controlled
Electrocompaniet unit. See chapter 1.8 for detailed description.
6. Acceleration sensor
Change the sensitivity of the touch control wheel by pressing arrow left or right.
7. Deep sleep
Press OK for activating deep sleep.
Attention: The reset button or a USB connection must be used for waking
up the ECT3 from deep sleep.This function is meant for transportation and
air shipments only.
8.Product Dimming
Press arrow left and right for changing the
display light intensity of supported units, RF
units only.
ATT: This feature will not change the
display light on your ECT3.
Press EXIT or OK for the previous page.
STANDBY mode
Press EXIT for more then 2 seconds for activating STANBY for all sup-
ported RF-controlled Electrocompaniet products.