ENMET SE-5175 - Manual (Page 3)

SE-5175 ENMET Corporation
1
1.0 Introduction
The SE-5175 sensor/transmitter (S/T) instrument is a 3 wire, 24 V DC , 4-20mA S/T, that measures and detects various types of
toxic gases utilizing an electrochemical sensor. The SE-5175 is N OT in an enclosure rated for use in a Class I, Div 1, Groups
B, C, D classified area and C AN N OT be installed in a hazardous location, as defined by the National Electric Code (NEC).
Features of the SE-5175:
continuous monitoring of the sample air
continuous LCD display of gas and vapor concentrations
menu driven operational and maintenance controls
menu driven calibration procedure
mA outputs for target gas
Sensor/Transmitter are three wire device, with two of the wires forming a 4-20mA loop
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the SE-5175 and examine it for shipping damage. If such damage is observed, notify both ENMET customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase Order and Sales Order
numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to
ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of
receipt at the following address:
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the SE-5175 is received as ordered. Each SE-
5175 is labeled with its target gas. If there are accessories on the order, ascertain that they are present. Check the contents of
calibration kits. Notify ENMET customer service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each SE-5175 is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.