ENMET SE-5175 - Manual (Page 5)

SE-5175 ENMET Corporation
3
2.3 Circuit Board Features
The Display Panel is attached to the enclosure cover and is released by unscrewing the 4 screws located in the corners. After
releasing the screws and lifting the cover and exposing the interior of the enclosure, see section 3.0 for installation and wiring
instructions. The Circuit Board is mounted at the back surface of the enclosure Cover.
Circuit Board Features are shown in Figure 2.
Feature Description
Output Terminals J4 plug – Terminals to controller
Sensor Wiring J8 plug – Terminals to sensor wiring
Figure 2: SE-5175 Circuit Board Features
J4 Terminal
4-20mA Output
Terminal J8
To Sensor Wiring