Eurocom LV220 ViiVA - Manual (Page 91)

Modules
Setting Up SATA RAID or AHCI Modes 7 - 3
7
Prepare the following before setting up your Serial ATA hard disks in RAID or
AHCI mode:
1. The Microsoft Windows Vista OS CD.
2. The second hard disk (required for RAID but not required for AHCI) installed in
the optional device drive bay (see page
6 - 3 ).
SATA RAID or AHCI Setup Procedure (BIOS)
3. Start-up your computer and press <F2> to enter the BIOS.
4. Go to the Advanced menu.
• For RAID Mode: - Set "SATA RAID Enable" ( “SATA RAID Enable:
(Advanced Menu)” on page 5 - 9 ) to "Enabled".
OR
• For AHCI Mode: - Set "SATA AHCI Enable" (
“SATA AHCI Enable:
(Advanced Menu)” on page 5 - 9 ) to "Enabled".
5. Press Esc and go to the Boot menu.
6. Set the external CD/DVD-ROM Drive (make sure the Microsoft Windows OS
CD is inserted) as the first device in the boot order from the Boot menu.
7. Attach the external USB floppy disk drive to one of the computer’s USB ports.
8. Select Exit Saving Changes from the Exit menu (or press F10 and Enter) and
press Enter to exit the BIOS and reboot the computer.