Eurocom M660N MILANO - Manual (Page 33)

System Map: Left View 1 - 13
Quick Start Guide
1
System Map: Left View
1 5
2
4 6 3 7

Changing DVD Regional Codes
Go to the Control Panel and double-click Device
Manager (Hardware and Sound), then click the +
next to DVD/CD-ROM drives. Double-click on the
DVD-ROM device to bring up the Properties dia-
logue box, and select the DVD Region (tab) to bring
up the control panel to allow you to adjust the regional
code (see
“DVD Regional Codes” on page 2 - 5 ).
DVD region detection is device dependent, not OS-
dependent. You can select your module’s region
code 5 times. The fifth selection is permanent. This
cannot be altered even if you change your operating
system or you use the module in another computer.
Figure 1 - 5 - Left View
1. Security Lock Slot
2. Optical Device Drive Bay
(see page
2 - 3 )
3. RJ-11 Modem Jack
4. S/PDIF-Out Jack
5. Microphone-In Jack
6. Headphone-Out Jack
7. Line-In Jack

CD Emergency Eject
If you need to manually eject a CD/DVD (e.g. due to an unex-
pected power interruption) you may push the end of a straight-
ened paper clip into the emergency eject hole. Do not use a
sharpened pencil or similar object that may break and become
lodged in the hole.
Media Warning
Don’t try to remove a floppy disk/CD/DVD while the system is
accessing it. This may cause the system to “crash”.