EXFO BV10 Performance Endpoint Unit - Manual (Page 68)

CLI Command Reference
62 BV10
Configuration Commands
console in-band enable|disable
Description Enables or disables in-band management on the Test port. By default,
in-band management on the Test port is enabled.
This command displays no output unless there is an error.
This command is not available through the Test port.
Syntax console in-band enable|disable
Example bv10-100> console in-band disable
console in-band port port_value
Description Configures the port number that can be used to communicate with the
BrixWorx server from the Test port.
Syntax console in-band port port_valueh
Example bv10-100> console in-band port 300
console telnet|ssh|serial idle-timeout value_in_seconds
Description Sets the idle timeout for the Telnet server, SSH server, or serial console
communication session. Each connection method can have its own
timeout.
By default, no idle timeout is set. The minimum idle timeout is 30
seconds. To disable the idle timeout, enter 0 (zero).
This command displays no output.
Syntax console telnet|ssh|serial idle-timeout value_in_seconds
Example bv10-100> console telnet idle-timeout 900