EXFO BV10 Performance Endpoint Unit - Manual (Page 74)

CLI Command Reference
68 BV10
Configuration Commands
interface lan|test address-netmask IP_address/netmask|dhcp
Description Sets the IP address and subnet mask for the LAN or TEST port either
manually or using DHCP.
DHCP is enabled by default on the TEST port; it is disabled by default on
the LAN port.
The LAN port is set to IP address 10.10.10.10/255.255.0.0. When DHCP is
enabled, the local IP parameters are acquired from a DHCP server, as
defined in RFC2131. The CLI provides information about the DHCP
acquisition status and the lease (expiration time). For more
information, refer to show interface on page 51
The BV10 supports IPv4 addressing. The netmask value can be
specified in either dotted decimal notation or CIDR format. For
example:
192.168.1.1/255.255.255.0
192.168.1.1/24
Syntax interface lan|test address-netmask
IP_address/netmask|dhcp
Example bv10-100> interface test address-netmask 10.10.10.181/24
address-mask: changing static address to 10.10.10.181/255.255.255.0.
interface lan|test gateway IP_address|none
Description When the LAN or TEST interface IP address of the port is manually set,
sets the gateway to the specified IP address or none. When the IP
address of the port is changed from DHCP to manual, the default
gateway is automatically set to manual using the last acquired default
gateway IP address. The gateway can still be configured to none.
Syntax interface lan|test gateway IP_address|none
Example bv10-100> interface lan gateway none