EZ-ACCESS PASSPOR User Manual
Page 3
Page | 3
Hardware Bag Contents for
Straight Through Platform
Hardware Bag Contents for
90° Turn Platform
ATTENTION INSTALLER
– VERIFY PRIOR TO INSTALLATION:
Check for shipping damage immediately upon receipt.
Note any freight damage on freight bill while driver is still present. In most cases, freight damage claims will not be
allowed unless noted on the freight bill. Pictures of damage before the unit is unpacked can be very helpful.
Contact shipper right away with any freight damage concerns.
The VPL is shipped with a packing list. Confirm all items are present before starting installation.
Layout installation site taking into consideration VPL entry and exit points, height, and electrical supply location.
Th
e VPL platform must be at least 3/8” but no more than 3/4” from the edge of the upper landing (horizontally).
The VPL platform guard walls must be at least 2” but no more than 3” (horizontally) from walls or other obstructions.
It is the installer’s responsibility to verify local codes and regulations regarding power supply and electrical
connections. The VPL is supplied with a 12’ AC power cord.
The VPL must be anchored to a level, 3,500 PSI concrete pad at least 4” thick. Minimum pad dimensions are 41” x
50” to anchor the legs and support the tower. However, a larger pad will be needed if it is desired that the guard
ramp land on the pad and/or the approach to the ramp be incorporated into the pad. Final pad location, orientation
and dimensions ar
e the installer’s responsibility to determine based on field conditions.
Confirm the structural integrity of any existing fascia.
Verify that the upper landing area is level.
Determine which side the guard ramp will be attached to and verify adequate clearances.
Check for adequate headroom clearance above VPL platform. The PL52SP3651 and PL52TP3860 require
approximately 100” to travel to its maximum platform height not including the occupant. The PL72SP3651 and
PL72TP3860 require approximately
120” to travel to its maximum platform height not including the occupant.
Platform must travel up and down and guard ramp must fold and unfold without interference or obstruction.
Refer to the Top Landing Gate Placement and Installation section if installing a Top Landing Gate.
Read and understand the entire Installation Manual before proceeding with installation.
Please leave User Manual with the VPL user.