EZ-ACCESS PASSPOR - Manual (Page 40)

Page | 40
8. Route the red wire (attached to yellow fuse wire in FIG. 11.6) down through the cable access port (FIG.
5.6) and run parallel to the AC power cord down right side of lift tower behind wire hold-downs. (FIG.
5.7, 11.6). String red wire down to match the length of the other two plugs (FIG. 11.7).
FIG. 11.7
(Only use jumper without gate)
FIG. 11.8 FIG. 11.8a
9. Locate the 4-pin female connector on end of the rainbow ribbon cable near base of tower and remove
the gate bypass jumper (FIG. 11.7). Connect the 4-
pin male connector end of 14’ SOOW cord to this
plug and join the single red wires with the attached 1/4 ” male and female spade connectors (FIG. 11.8).
Route cord out through notch in rear tower cover panel. (FIG. 11.8a).
10. From front side of tower, locate the blue wire from gate bypass switch (wire No. 4 on right side of
carriage) where it joins the black wire J3H from female 8-pin connector on left side of carriage and
disconnect the spade connector where the wires join. (FIG. 11.9).
FIG. 11.9 FIG. 11.10
11. Connect the male spade connector on the end of the 16” black wire with the 1/4” ring terminal on the
opposite end to the female spade connector on the blue wire disconnected in the previous step. (FIG.
11.10).