E-Z-GO TERRAIN 250 - Manual (Page 28)

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
3 - 4
3
Located on the dash panel, the key switch enables the electrical system of the vehicle to be turned on and off by turning
the key and the headlight is operated by turning the key switch beyond ON position. To prevent inadvertent operation of
the vehicle when left unattended, the key should be turned to the ‘OFF’ position and removed
2. State of Charge Meter
The vehicle is equipped with a state of charge meter located in the dash panel. The state of charge meter indicates the
amount of usable power in the batteries. The state of charge meter shows the condition of the battery pack with F indi-
cating a full charge on the battery pack and E indicating the battery pack needs to be charged.
3. Direction Selector
To prevent loss of control, do not move vehicle direction selector while the vehicle is in motion.
Moving the selector will result in sudden slowing of the vehicle and the beeping of a warning
device.
Located on the dash panel, this switch permits the selection of either ‘F’ (forward), ‘R’ (reverse) or neutral (the posi-
tion between forward and reverse). Vehicle should be left in neutral when unattended
4. Accelerator Pedal
Unintentional movement of the accelerator pedal will release the park brake and may cause the
vehicle to move which could result in severe injury or death.
With the key switch ‘ON’, depressing the accelerator pedal starts the motor.When the pedal is released, the motor
will stop. To stop the vehicle more quickly, depress the service brake.If key switch is ‘ON’ and park brake is set,
depressing the accelerator inadvertently will release the park brake and will cause the vehicle to move which could
cause severe injury or death.
Depressing the accelerator pedal will release the park brake if it is engaged. This is a feature to assure the vehicle is
not driven with the park brake engaged.Depressing the accelerator pedal is not the preferred method of releasing the
park brake.
5. Brake and Park Brake
If the vehicle is equipped with factory installed custom accessories, some accessories remain operational with the key switch in
the ‘OFF’ position.
The brake pedal incorporates a park brake feature. To engage the park brake, push down on the upper section of the
pedal until it locks in place. The park brake will release when the service brake pedal is depressed. Use the lower
section of the brake pedal to operate the service brake system.
6. Horn
The horn button is located on the driver’s side floorboard; depressing the button will sound the vehicle’s horn.
7. Rear View Mirror
The rear view mirror is a two-position mirror manually adjusted for day and nighttime conditions.Sun Top kit is
required to install rear view mirror.
NOTICE