E-Z-GO TERRAIN 250 - Manual (Page 34)

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
4 - 2
4
SERIAL NUMBER LOCATION
Two serial number and manufacture date code plates are on the vehicle. One (PART C) is placed on the body below
the front, driver side of the seat, PART D is placed on the frame weld tube. The other (PART A and PART B) is
located on the crossmember section of the chassis on the driver side (seat back support). To access it, raise the seat
and lift up the flap on the access panel.
Design changes take place on an ongoing basis. In order to obtain correct components for the vehicle, the manufac-
ture date code, serial number and vehicle model mustacture date code, serial number and vehicle model must be
provided when ordering service parts.
Serial Number and Location
BEFORE INITIAL USE
Read, understand and follow the safety label on the instrument panel. Be sure you understand how to operate the
vehicle, its equipment as well as how to use it safely. Maintaining good performance depends to a large extent on the
operator.
Improper use of this vehicle could result in severe injury or death. The series of vehicles are light
duty utility vehicles. They are NOT All Terrain Vehicles (ATV’s).
V
PA
RT
B
PA
RT
C
/D
PA
RT
A
Part C
Lift Flap on Access Panel
Serial Number
Labels
Part A
Part B
Part D
V