DYSON DC07 - Manual (Page 10)

Using the tools
A
B
C
Using the tools
Choosing the right tool
The tools allow you to clean
surfaces above the floor and
to reach hard to clean areas.
Ensure the machine is in an
upright position before
using tools.
A Brush tool – with soft bristles
to dislodge dust and cobwebs.
Can be used to clean vents
and some furniture.
B Stair tool – with velour strips
to pick up hairs and an
agitating edge to lift the
carpet. Can be used to clean
stairs and upholstery.
C Crevice tool – reaches deep
into nooks and crannies.
Can be used to clean
along baseboards and in
tight spaces.
CAUTION
Do not use your vacuum cleaner
outdoors or on wet surfaces.
Vacuum may be used inside a
garage only when used with the
Model 08909 Dyson Car
Cleaning Kit accessories. If used
in a garage, care should be
taken to wipe the soleplate and
wheels with a dry cloth after
vacuuming to clean off any
sand, dirt, or pebbles that could
damage delicate floors.
How to clean your tools
The brush tool, stair tool, and
crevice tool may be washed in
warm water with a detergent.
Rinse and air dry thoroughly
before using. You may wipe the
outside of the floor tool or turbo
tool/mini turbine head with a
damp cloth, but do not
submerge in water. Do not
attempt to clean any tools when
they are attached to the machine.
1
2
Dyson Helpline contact us at 1-866-693-9766 7 days a week 10
Attaching tools
Use tools for easier cleaning in hard
to reach areas.
1 Press the wand release to detach
the wand from the machine.
2 Pull wand up to extend hose, slide
the hose away from the wand
until the metal tube and hose cuff
click into place.
All Dyson tools can be used
in the following ways:
Wand mode
Slide back the wand cap and fit one
of the tools directly on the
wand handle.
16852_DCO7_OP_MAN_US.qxd 5/7/07 14:00 Page 10 (Cyan plate) (Magenta (PANTONE plate) (Yellow plate) (Black plate) Red 032 C plate)
10:39:28 2007-07-06 C_16852_DCO7_OP_MAN_US_4c1s.pdf