DYSON DC07 - Manual (Page 15)

Clearing blockages
U-bend
• Tilt the machine forward to
slide out the U-bend.
• Check inside for blockages.
Airway inspection valve
• Squeeze the valve release
buttons to remove the airway
inspection valve.
• Check inside for blockages.
CAUTION
• The ratcheting noise may
warn that the brushbar is
obstructed. If this occurs,
unplug the machine from the
electrical outlet before
removing the obstruction.
1
2
15
www.dyson.com
3
Brushbar
Lay the machine on its front.
1 Undo the colored soleplate
fasteners using a coin and
remove the soleplate.
2 Clear the brushbar obstruction,
carefully cutting away any
threads with a pair of scissors.
3 Replace the soleplate and
tighten the fasteners.
When replacing the soleplate,
the soleplate must be fitted
securely with the bottom of the
cleanerhead to achieve optimal
performance. Check the
alignment of the soleplate with
front edge of cleanerhead.
16852_DCO7_OP_MAN_US.qxd 5/7/07 14:00 Page 15 (Cyan plate) (Magenta (PANTONE plate) (Yellow plate) (Black plate) Red 032 C plate)
10:39:28 2007-07-06 C_16852_DCO7_OP_MAN_US_4c1s.pdf