HITEC X2-400: DC/DC Dual Port Charger - Manual (Page 21)

19
Set the charge current on the left and the nominal voltage on
the right. Charge current can be set from 0.1-6.0A. The voltage
must match the battery being charged. Press the
START/ENTER key for more than 3 seconds to start charging.
The screen will display the real-time charging status. Press the
START/ENTER key to alter the charge current. Press the
START/ENTER key again to store the parameter settings you
set. Press the BATT TYPE/STOP key to end the program.
Discharging Lead Acid (Pb) Batteries
NOTICE
Due to the chemistry characteristic of a Pb battery, the cut-off point may be difficult to
detect at times. We recommend you use the CAPACITY CUT-OFF feature to protect the
battery. Refer to the Default User Preferences Setup section of this manual to set up
this feature.
Charging Lead Acid (Pb) Batteries
Set up the discharge current on the left and the nominal
voltage on the right. The discharge current can be set from
0.1-5.0A. The voltage should match the battery being
charged. Press the START/ENTER key for more than 3
seconds to start discharging.
The screen displays the real-time discharging status. Press
the Start/Enter key to alter the discharge current. Press the
Start/Enter key again to store the parameter value you set.
Press the BATT TYPE/STOP key to end the program.
CHARGING / DISCHARGING LEAD-ACID (PB) BATTERIES
DEC INC DEC INC
‘>3 seconds’
Batt Type
Stop
Start
Enter
DEC INC DEC INC
‘>3 seconds’
Batt Type
Stop
Start
Enter
Battery
Type
Elapsed
Time
Battery
Voltage
Charged
Capacity
Charge
Current
Battery
Type
Elapsed
Time
Battery
Voltage
Discharged
Capacity Discharge
Current